• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Drews Precision Lathe chuck adapter

Woollybugger

Gold $$ Contributor
Dustin Drew’s barrel chuck adapter demo.
He makes these for Manson.

 
Last edited:
Dustin Drew’s barrel chuck demo.
He makes these for Manson.

It's a 16C Collet Chuck. Available from Bison, TMX Toolmex, Pratt Burnard Atlas, etc.
 
He says he was having chatter from his tru-bore, So thats why he came up with his new chuck system. If you go back to Nates old videos on the tru-bore he says to barely hold the other end of the barrel with your outboard spider.

I make extensions for my barrels so I can support the other end of the barrel on my tru-bore setup if the barrels aren't long enough..
 
He says he was having chatter from his tru-bore, So thats why he came up with his new chuck system. If you go back to Nates old videos on the tru-bore he says to barely hold the other end of the barrel with your outboard spider.

I make extensions for my barrels so I can support the other end of the barrel on my tru-bore setup if the barrels aren't long enough..
He chambers raw straight full dia blanks and contours them after he chambers so the length should not be an issue.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
168,970
Messages
2,266,771
Members
81,699
Latest member
dezenutz
Back
Top