joelpend
Silver $$ Contributor
Full Custom, Barely broken in. This entire pistol is coated with Ion Bond which is a superior hard and wear resistant PVD coating. Very few places even show coating wear. This is one soft shooting 9MM pistol. The slide is lightened and it runs on a 7lb recoil spring. This was built for Outlaw 3 Gun Competition but was used very little before I quit shooting those matches. No expensive was spared building this pistol. Built by PGW.
Phoenix Trinity Stainless Frame (Aggressive texture with the sharpness slightly tempered)
STI slide with generous lightening cuts and enhancements
Dawson Sights (Bomar cut) (Included is a plate that fits the Bomar cut for a Holosun/RMR)
SVI 2lb Trigger
Skeleton Hammer (I think SVI)
STI steel magwell
Schueman Ultimatch Barrel
(4) 23 rd Mags with Taran Tactical base pads (These all run flawless) (1) Stock Mag (18-19 rds?)
Blade Tech Holster with Drop Offset and Safariland Clip, also 3 competition magazine pouches (not shown)
Asking $3200 OBO + Shipping
Phoenix Trinity Stainless Frame (Aggressive texture with the sharpness slightly tempered)
STI slide with generous lightening cuts and enhancements
Dawson Sights (Bomar cut) (Included is a plate that fits the Bomar cut for a Holosun/RMR)
SVI 2lb Trigger
Skeleton Hammer (I think SVI)
STI steel magwell
Schueman Ultimatch Barrel
(4) 23 rd Mags with Taran Tactical base pads (These all run flawless) (1) Stock Mag (18-19 rds?)
Blade Tech Holster with Drop Offset and Safariland Clip, also 3 competition magazine pouches (not shown)
Asking $3200 OBO + Shipping
