HI
Has any one tried this on Stainless steel parts and how did they come out??
I have midical instuments that I use quite regularly to change dressings and such.
Also do you put cases in mouth up or mouth down in the beakers??
I have looked at Egay for an ultrasonic- how do you tell a good one
-what features should a good one have? is there a point of deminishing returns if I buy a large one to do the ling clamps in one go V doing them half and half in a smaller unit.
Can you uverlaod these units and how do you tell when you have??
later
p
Has any one tried this on Stainless steel parts and how did they come out??
I have midical instuments that I use quite regularly to change dressings and such.
Also do you put cases in mouth up or mouth down in the beakers??
I have looked at Egay for an ultrasonic- how do you tell a good one
-what features should a good one have? is there a point of deminishing returns if I buy a large one to do the ling clamps in one go V doing them half and half in a smaller unit.
Can you uverlaod these units and how do you tell when you have??
later
p
