• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Case growth from turning ?

I working on my first 6br, new Lapua brass, and I'm turning with a K&M for a 262 neck. Cases are 1.555 to 1.556 new. I turned them down to .009 in three passes, and now the cases are about 1.568. Was I too aggressive? or is this normal?

Jim
 
I just bought a box of 100 pcs.I have only had time to turn 50 so far.I checked the turned and unturned cases and there was no difference in lenght,but don't go by me...I'm a noobie at this BR stuff.

Dean
 
The cases are not sized but I did use a K&M Case Neck Expander to open them up to fit the neck turner.,which is brand new) if it is not sharp it would be a new defect.

I'm going to run a few through the neck expander only and measure.

Thanks,
Jim
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,840
Messages
2,204,735
Members
79,164
Latest member
missouribirdman
Back
Top