ballisticdaddy
Gold $$ Contributor
If you use the Burstfire induction annealer and shoot any of the BR or ARC cartridges the factory setup will not anneal past the shoulder with these short cases. This aftermarket turret, along with the post cap, gains just over 3/8" additional depth and works perfect for these little cartridges. Uses all the factory hardware and takes less than 5 minutes to swap it out. 3D printed using PET-CF which is lighter, stronger and just as temperature resistant as the factory delrin turret. Asking $40.00 shipped for the turret and post cap, please PM to order or if you have any questions.
