BRX Trimming brass, to what measurement

[fm1947]

Are you trimming if so to what?

 

[djporter]

Are you trimming if so to what?

.010” short of chamber length. If the chamber length is longer than the case length say .020” or so and I can not hold that, then just all of the the same length.

 

[fm1947]

.010” short of chamber length. If the chamber length is longer than the case length say .020” or so and I can not hold that, then just all of the the same length.

That makes sense, thanks

 

[fm1947]

.010” short of chamber length. If the chamber length is longer than the case length say .020” or so and I can not hold that, then just all of the the same length.[/Q


i forgot I lost my print of reamer so I googled this very interesting, the original reamer, my brass is 1.547 and some at 1.543, here's the article good info http://bulletin.accurateshooter.com/2012/08/myth-busters-ii-bob-crones-6mm-brx-by-robert-whitley/