Bore Guide

[ChrisT]

Can someone steer me in the right direction ,I am after a bore guide for a V1 Turbo action,I dont want one of those junk plastic things that are a bore guide when you dont really have a bore guide.I am using a .20 Pro shot rod and want a close fitting guide,preferably one that does not butt right up against the chamber,it so far seems like I will have to make one,any suggestions.


Regards Chris.

 

[katokoch]

Check this out: http://www.mwerksllc.com/turbo.php

 

[Fotheringill]

MWerks will make you anything you want. It will cost, but it will fit.

 

[ChrisT]

That looks like just what I was looking for ,thank you very much.

 

[Mikey_P]

MWerks will make you anything you want. It will cost, but it will fit.

+1. I use an MWerks boreguide on my Anschutz match rifle. And, if you want to really do it right IMHO, go here for your cleaning rod - http://www.ivyrods.com/CleaningRODS.htm. Top shelf quality...

Mike

 

[Fotheringill]

Mikey +1

I have a steel Ivy rod for my 1913a and it works like a dream (.187 shaft) and VERY easy to wipe off during and after use. IMHO, much easier than the composite rods.

I found Ivy pretty slow on manufacture and shipping, but ultimately worth the wait.