Best Tool For Checking Run Out

[chuckw2]

I am going to buy a tool to check the run out on my match loads.
Which one would you recommend?


Thanks,

Chuck

 

[chino1969]

I have the Sinclair model and have been satisfied with it. The beauty of a runout gauge is that it will, in addition to other features, allow you to pinpoint die problems.

 

[chuckw2]

If the NECO and Sinclair Gage were the same price which would you buy and why?


Chuck

 

[chino1969]

I did look at the NECO when I was shopping but chose the Sinclair because I just needed a runout tool. I check my neck thickness with a tubing micrometer, so that feature of the NECO runout tool held no appeal for me. I have not compared the two side by side, so I cannot accurately answer your question. If you have a need for all of the features the NECO model provides, you may want to consider it over the Sinclair. The reason I like the Sinclair is that the case is supported by embedded bearings, is very smooth and quick to change settings for different case sizes.

 

[Anmlsrdelicious]

Bought my Sinclair for the same reasons as the above posters. Simple, easy to use, and I did not need any extra features.