Barnard P trigger shoe pin retainer size?

[FatBoy]

Does anyone know what size the retainer clip is for a Barnard P trigger shoe retainer pin? Mine has taken a permanent leave of absence and the pin would be gone too if the Eliseo trigger guard didn’t keep it from backing out to the point of falling out.

A follow up would be do you know where to pick some up? I have an email out to Whidden but I want to cover my bases.

 

[Stumpy1]

Hi Chris,

I don't know the size offhand (but I guarantee it's metric), I am sure you can find one here;

https://www.mcmaster.com/e-clips

Hope this is useful,

Frank

 

[FatBoy]

I was on their site earlier. Unfortunately I have no way to measure this tiny pin groove.

 

[clowdis]

The pin is 2mm OD. So you can order a pkg. https://www.mcmaster.com/98543A101 and a pkg. of https://www.mcmaster.com/98543A103 one of which should be correct. Both are for 2mm pins but I cannot measure the actual groove diameter. At $3 a pkg I'd buy both and use the one that fit best.

 

[FatBoy]

The pin is 2mm OD. So you can order a pkg. https://www.mcmaster.com/98543A101 and a pkg. of https://www.mcmaster.com/98543A103 one of which should be correct. Both are for 2mm pins but I cannot measure the actual groove diameter. At $3 a pkg I'd buy both and use the one that fit best.

excellent. Thank you. These say 4-5mm? I’ll poke around.

Whidden does have them as well.

I may never need one again but you can bet I’ll have enough in my range bag to repair the firing line at a regional from now on.

 

[clowdis]

excellent. Thank you. These say 4-5mm? I’ll poke around.

Whidden does have them as well.

I may never need one again but you can bet I’ll have enough in my range bag to repair the firing line at a regional from now on.

Oops, you're right. Maybe just get a couple from Whidden and then you know you have the correct ones.

 

[FatBoy]

I would bet one of these will work. Once I get a couple from Whidden I’ll measure and post it up.