Ballistics AE

[Kramerica]

I have no idea what to put in for the "Elevation Turret" and "Windage Turret" settings in the output section. I'm running a NF 5-25x56 F1 scope. Mil/mil turrets. If I leave it at the default 1.000 my trajectory is no where close to right. It's probably something obvious but some input would be appreciated.

 

[fredo]

ON TRAJECTORY SCREEN, Under "Output Options" section...

6th line down is: "Elevation Units"
Select: "mRAD"

Next is: "Windage Units"
Also Select: "mRAD"

Next is: "Elevation Turret"
Input: 1.000 (value)

Next is: "Windage Turret"
Input: 1.000 (value)

That should do it.

I suspect you may have line 6 & 7 Units set to ".1mRad clicks", or one of the other options?

Make sure they're both set as "mRAD"

 

[Kramerica]

ON TRAJECTORY SCREEN, Under "Output Options" section...

6th line down is: "Elevation Units"
Select: "mRAD"

Next is: "Windage Units"
Also Select: "mRAD"

Next is: "Elevation Turret"
Input: 1.000 (value)

Next is: "Windage Turret"
Input: 1.000 (value)

That should do it.

I suspect you may have line 6 & 7 Units set to ".1mRad clicks", or one of the other options?

Make sure they're both set as "mRAD"

Yes I used the .1mRad. I knew it was probably something simple. I was thinking tenth mil clicks. Thank you for the help