Aztec codes for 6br

[mr45man]

I fried a couple of Fired Lapua cases in analyzing mode.
the code was 0153 and 0154. Is that about right.?
no idea what lot # is,had this stuff for years.
Just wondering .

 

[bugman]

That is about right if this is unturned brass. Most turned 6BR brass will record a slightly lower code, and the lower code directly proportional to how thin the necks are turned. In other words, the Aztec code is linear. You will also find that gold box is usually a higher code than blue, and that is partly a function of brass thickness

 

[Drolds72]

With my necks turned to .0105-.0106 my Aztec code is 142.

 

[mr45man]

Ok thanks , my brass is Unturned. Used fired many times.
i recently bought 100 new Lapua br brass , just can not bring my to fry one in Aztec yet.

 

[Drolds72]

Ok thanks , my brass is Unturned. Used fired many times.
i recently bought 100 new Lapua br brass , just can not bring my to fry one in Aztec yet.

Did you count them? A lot of times they throw in an extra

 

[PopCharlie]

With my necks turned to .0105-.0106 my Aztec code is 142.

I get the same code with necks turned to .0105.

 

[PopCharlie]

Did you count them? A lot of times they throw in an extra

Or 2 or 3....ive had up to 3 extras.
PopCharlie

 

[PopCharlie]

I got a 152 on unturned Lapua 6br
PopCharlie

 

[mr45man]

Did you count them? A lot of times they throw in an extra

Nope, filled 2 MTM boxes no extras. ☹

 

[mr45man]

I got a 152 on unturned Lapua 6br
PopCharlie

Thanks,
So within 1 and 2 . I'll call it good.
Love this machine, plug it I, put in code , start annealing. About 4 seconds per case.

 

[mr45man]

I get the same code with necks turned to .0105.

Thanks.

 

[Big_Daddy]

I get 152 on mine also.

I just added the AMP Mate to mine.....Oh boy!!!

 

[mr45man]

I get 152 on mine also.

I just added the AMP Mate to mine.....Oh boy!!!

So these machines can give very similar codes , I'm impressed.

 

[jerryobush]

I get the same code with necks turned to .0105.

With turned necks, my code is 139.

 

[mr45man]

With turned necks, my code is 139.

How much turn?

 

[08glide]

With necks turned to 0.012 my Aztec gives code 157 on my current lot of Lapua brass.

 

[GetReal]

A bit off topic, but w/ one manufacturer (Peterson) .... the AMP gave a 0134 analyzed code where Peterson recommended 0126. Different batches?

Not to disucss Peterson per se, but I'm guessing use the AMP analyzed code over the manufacturers recommend..... right?

Also what is the diff btwn the AZTEC COde here ( https://www.ampannealing.com/aztec-settings/ ) for 6 Dasher of 052A vs. the Analyzed Code I got of 0134?

Thanx.