ATTN: Aluminum CNC guys... question

[rardoin]

Anyone thought about CNC machining an aluminum drying rack to slip cases onto upside down to drip and View attachment 1000880
dry after wet tumbling?

Something along this kinda line but CNC out of aluminum?

It would take a very large and expensive piece of rectangular stock to start with...then quite a lot of spindle run time with a long small diameter end mill. The costs would be as much as barrel blank most likely.

 

[jdh47]

I just use the oven and a mixing bowl. It is quick easy and sure to start a stimulating conversation.

Joe

 

[ireload2]

I use the old yeller Flambeau Twin 60 loading blocks.
First I rinse wet cases in 90% or 99% isopropyl alcohol. Then I roll the brass in a clean towel I stand the cases in the loading block leaning to one corner and place in front of a fan where they will dry in about 10 minutes. The alcohol absorbs the water and evaporates.

 

[21shooter]

Hi, This is what I use, just remove it from the red box. I put them in the oven 150deg. for 2-3 hrs NO they don't melt, Well intel the wife decides to bake something at350deg. Thanks, John
http://www.xxicsi.com/products-1.html