AGN Rattler POI

[hipp2412]

I have a AGN Rattler thermal scope. I have the windage set where I need it but I am high at 100 yds. I want to move the POI down about 1 1/2 inches. So this is where my dumbness comes in. Do I move the “Y” plus or minus? I’ve attempted to move this and it can be really low or even higher. This is nothing like sighting in a regular scope! Thanks

 

[Coyotefurharvester]

You are moving the image to the bullet impact to calibrate. Remember to save the change. And if your thermal displays the x,y after the save,write it down.

 

[hipp2412]

So if I’m 2” high I would move the reticle to the impact point but I would like to be an inch high at 100.

 

[Coyotefurharvester]

Than go 1/2 way to the bullet impact. Just remember the reticle doesn't stay "centered" like a traditional scope. So depending on your mount and bullet velocity the ballistic trajectory curve may not follow the expected points of impact. You probably will need to shoot every 50 yards out to max shooting range.

 

[hipp2412]

Thank you..