6xc loads

[338 Mollett]

Anybody tried n 160 in a 6xc? Post results please.

 

[wc872]

I believe that David Tubb used N160 in the 6xc. I just got done doing a test out to 1000 yards. My accuracy load for the 6xc with my particular Lot of H4350 is 38.6grs. H4350. I only used the 115 DTAC's that are Boron Nitrided. I started with 39.0 grs. of N160 & worked up. I ended up with a load that shot just as accurate as the H4350 load & using the same elevation setting shot to the same point of impact @ 1000 yards.
I did not get any real accuracy improvement but I didn't loose any accuracy either. While it takes more N160 to get the same results in my rifle at least I have a supply of N160 while my supply of H4350 is lower than I would like.
Semper Fi

 

[338 Mollett]

Thank you for the reply!

 

[confuzed]

try 40 to 41 grains of h4831sc I have good results with 40.6 and a 108 berger 10 thou into the lands

 

[jcampbellsmith]

I believe that David Tubb used N160 in the 6xc. ....

Spot on.
http://www.davidtubb.com/davidtubb/content/graphics/pdfs/6XC_die_instructions_2012.pdf
You need to read to the final page of the .pdf
Regards JCS