6x45 small game load

[Rem700Fan]

Just to add some more versatility to the 6x45. I wanted to work up a load that was similar to a 22LR. My rifle is a REM 700 so this would not cycle an AR. Hodgdon has reduced loads for the .223 using Titegroup. So that is where I started. I chose the Speer 75hp. Very inexpensive. I started with 4.0 grains and got a very mild 1032 fps. I stepped up to 5.0 grains and I was very happy with 1,330 fps. 25 yard groups can be covered with a dime. 50 yard groups under a quarter. Minute of squirrel.

 

[Oso]

That’s nice results. Did you consider using a lighter weight 6mm bullet?

 

[swd]

That sounds fun and a pound of powder will last forever! How loud is it?

 

[muleystalker]

Did you have to stuff polypill or something over the powder since its such a small charge?

 

[topsail86]

65 VMAX over 10 grains Lil Gun gets me about 1900 FPS out of a 26 inch barrel. Very accurate at 200 yards. I use it for the high power division at Schuetzen matches. No recoil.

 

[Rem700Fan]

That’s nice results. Did you consider using a lighter weight 6mm bullet?

The 75 Speer was readily available and cheap. Compared to 60 grain. Plus I wanted the large hp.

 

[Rem700Fan]

That sounds fun and a pound of powder will last forever! How loud is it?

About as loud as a 22 mag

 

[Rem700Fan]

Did you have to stuff polypill or something over the powder since it’s such a small charge?

No, Titegroup is not supposed to be sensitive to light powder charges. I use it in 38 and 357 loads as well. Some powders need fillers to keep the powder charge near the primer.

 

[Oso]

No, Titegroup is not supposed to be sensitive to light powder charges. I use it in 38 and 357 loads as well. Some powders need fillers to keep the powder charge near the primer.

It is commonly used in subsonic load for 300BO and even .308 Win with no filler. It always surprises me when you think about only 9gr-12gr of Titegroup in a .308 case.