6mm Dasher reamer spec's ?

[Hal]

I was thinking about putting together a 6mm Dasher to shoot a couple of local matches, 600-1000 yds.
What brass do I need, what reamer spec's ( neck dia. or no turn) and who do I order dies from that will match the reamer?

I need will need all the help I can get.

Thanks
Hal

 

[Phil]

You will get a gang of answers for your question.... ;D

My advice would be to get your brass,then decide if you want to neck turn.

Having the brass will help you decide as you can check the necks for thickness and consistency.....

Seat the bullet you intend to use and check the neck thickness,order your reamer with the neck diameter you want...

Again you will get many opinions on neck clearance.....0015-.003 are most common.

Pacific tool and gauge is one place to order your reamer,there are probably 3-4 others as well.....again your choice.

Good luck,

Phil.

 

[rcw3]

I was thinking about putting together a 6mm Dasher to shoot a couple of local matches, 600-1000 yds.
What brass do I need, what reamer spec's ( neck dia. or no turn) and who do I order dies from that will match the reamer?

I need will need all the help I can get.

Thanks
Hal

Check out this Dasher page - a lot of what you may need here:

http://www.6mmar.com/6mm_Dasher.php

Robert

 

[Hal]

Robert

Very informative link.

Hal