6BR and Redding bushing die

[dieselten]

I will be starting to load for the 6BR for the first time in a couple weeks. I already have new Lapua brass and a Redding FL bushing die set. I have been reading about the expander ball causing run out on the cases during decapping/resizing. Should I decap seperately and remove the expander/decapper from the sizing die? I have a .268 neck bushing and the rifle is a factory Savage 6mm BR no turn neck.

Thanks
Nick

 

[Travelor]

Your question is a bit perplexing. The Redding collet die is made to size the neck using the colelt with NO expander button while depriming the case in one operation.

Also my experience with the Redding dies is that they neck size only and have a separate body for sizing the body of the cartridge case.

Maybe I am assuming something.

George

 

[holstil]

I think it's a good idea. I have a lee universal decapping die. Just be sure to use one for small flash holes.
The first thing I do is remove the ball from my dies, though I know people that get great results using them.
Redding is good stuff, I think you will like your's.


Jim

 

[dieselten]

This is the die set
http://www.midwayusa.com/viewProduct/?productNumber=286682

you can see the decapper pin sticking out in the picture, there is an expander ball attached to it inside. It is a Full Length sizer die.

Thanks holstil, I will look into a universal decapper