68gr Barts BT from a 243

[DLH_]

Recently purchased a custom 243 with a 1/10 Bartlein on. I know there are better bullets out there that the 1/10 can stabilise. However; I have a lot of the Barts in stock and was wondering, would they make a fantastically accurate, high velocity steel shooting bullet? Assuming around 3,450+ out of the 26in Bartlein. Does anyone have experience with them in a 243? On a side note, does anyone also know the G1 B.C of them?
Thanks everyone,

Josh.

 

[Tim Singleton]

The only answer I can give is they shoot fantastically accurate at 3450 fps

 

[Eric Leonard]

I aint tried the 68 Barts in a 243 but the 70 NBT with a good dose of IMR4064 shoots really tight,,really fast and really flat,,from a 26 inch 9 1/8 bbl they would go around 3700 and shoot really tight,,

 

[BartsBullets]

Recently purchased a custom 243 with a 1/10 Bartlein on. I know there are better bullets out there that the 1/10 can stabilise. However; I have a lot of the Barts in stock and was wondering, would they make a fantastically accurate, high velocity steel shooting bullet? Assuming around 3,450+ out of the 26in Bartlein. Does anyone have experience with them in a 243? On a side note, does anyone also know the G1 B.C of them?
Thanks everyone,

Josh.

Josh

By my calculations I get .284 G1. In the Grinch with a 13.5 Bartlien this week and ran the 68 Dominators up to 3550. They actually grouped pretty good there!

Bart

 

[DLH_]

Thank you everyone, I think I will just have to give them a go. Thank you Bart for the BC as well.

 

[Slickrick0999]

what about out of a 20" 1-8 twist .243?