6.5 PRC Fl bushing die.

[Bogusname]

I’ve never used different dies other than seater dies of similar cartridges. I chambered up a barrel in 7 prcw ec2. Logic says if I had a 6.5 prc fl bushing die I can swap out the bushings and be good. Any unforeseen hiccups that anyone knows about? It uses the same HS gauges.

 

[chromatica]

I purchased a Wilson 6.5 PRC bushing die for 7 PRCW. It didn't have enough clearance to accept my ADG 7 PRCW brass necks. I used a 5/16 drill bit to relieve the neck passage by a few thousandths to allow clearance for my .310 necks. (I have a standing drill press and a special vise for securing round stock.) I suspect that after I fire these cases for the first time, the necks might expand. If and when this happens, I will use an 8mm drill bit to relieve the neck passage a few more thousanddths.