6.5 prc brass

[Adam 6mm build]

Hello fellow shooters is Hornady the only one making brass for the new 6.5 prc I understand it's Hornady design

 

[alf]

That's it so far, but it's pretty good stuff.

 

[Zero333]

I assume Hornady will definitely pay attention to QC with their 6.5 PRC brass. If they don't then their new cartridge will not be as cool as they want it to be.

 

[FrankG]

We've had a few hundred and I don't see any issues with them.

One of my new 6.5mm barrels is going to be a 6.5PRC for a F open rifle.

Later, Frank
Bartlein Barrels

 

[JBT47]

Frank, thank you for participating on this forum. Always like reading your posts.

 

[wboggs]

Frank, thank you for participating on this forum. Always like reading your posts.

Frank. What twist you using? Any plans to try the SMK 150?

 

[Adam 6mm build]

My.new build is going to be a 7.5 twist can't wait thanks for the information men

 

[alf]

Mine's an eight twist, and spins the 150 SMK's just fine.....

 

[wboggs]

What velocity you running with the SMK 150's? I can't get good accuracy at 2700-2800

 

[FrankG]

What velocity you running with the SMK 150's? I can't get good accuracy at 2700-2800

Well I'll finally get around to shooting the new barrel. I'll probably throw 2 rounds thru it tomorrow and clean it and shoot another 5 and clean it. Then I'll do a group of 20 and clean it.

I'll shoot a few rounds of box ammo and I'll whip together some handloads. I'll keep ya posted.

My barrel is a 32" finish length.

Later, Frank