6.5 Dasher?

[willsnipe]

Gentlemen,
I'm looking at building the equivalent of a 6.5 dasher in a Mini-Mauser action, and find myself running into more walls than usual. Upon close inspection of the action, naturally post-purchase, The barrel threads are METRIC!!!!!!!!! Like many amateurs with older equipment, my lathe won't do the m-word. Any ideas on where I can get it barreled without being completely cost prohibitive? I figured the body could be cut with a dasher reamer & 6.5 pilot, neck and throat with nearly any 6.5 reamer,6.5-06, 260 etc.) I hate to give up on this project. Any help you could be would be greatly appreciated.

 

[dantec]

PAC NOR have metric lathe and the rebarreling job made by PAC NOR is OK

there is nothing difficult to cut metric or imperial as soon you can generate the pich, right gear set up )

you can go with conversion dims 1 inch = 25.4 mm
thread depht is 1.22 x thread pitch in mm

and you use a dial gauge in inch to get a direct reading in inch or you purchase a chinse 1/100 mm stroke 10 mm dial gauge and get a direct reading in mm .

I have rebarrel Minimauser thread, I have the tread drawing with specs if you need

good shooting

DAN TEC