Ajwilly96
Gold $$ Contributor
I put some new bolts in a front rest because I wanted longer ones. I designed and printed these up to make it easier to grab and adjust. They are the same diameter of the knobs on the Rodzilla.
The bots I used were a 3/4 head, once printed I lined it up on the bolt and smacked it a few times with a dead blow hammer. They are a very tight fit, so there should be no issues with slipping.
For the file labeled “test” I did it to save time and filament, with around a 5-10% infill to ensure they would fit. Then for the true print file I used a 100% infill.
Send me a PM if you’d like the files to be able to print them yourself!
The bots I used were a 3/4 head, once printed I lined it up on the bolt and smacked it a few times with a dead blow hammer. They are a very tight fit, so there should be no issues with slipping.
For the file labeled “test” I did it to save time and filament, with around a 5-10% infill to ensure they would fit. Then for the true print file I used a 100% infill.
Send me a PM if you’d like the files to be able to print them yourself!
