Mblmotors
Gold $$ Contributor
Selling 160 pcs one time fired Hornady 338 Lapua Magnum brass. I completely prepared the brass for priming and loading. This was my process:
1) Wet tumble
2) Anneal on Amp Annealer
3) Uniform the pockets
4) Resize F/L to SAAMI Spec bump shoulder .005 to .006
5) Trim to just over minimum length of about 2.715”
6) Chamfered inside and outside
7) Dry tumble to clean off wax and brass dust
I did mix in a piece of 338 S&B brass, so its 159 Hornady and 1 pc S&B.
Price shipped to continental US. $250
If you want, for another $50 I will prime them with Remington 9 1/2 Large Rifle Magnum primer.
Thanks for your consideration
1) Wet tumble
2) Anneal on Amp Annealer
3) Uniform the pockets
4) Resize F/L to SAAMI Spec bump shoulder .005 to .006
5) Trim to just over minimum length of about 2.715”
6) Chamfered inside and outside
7) Dry tumble to clean off wax and brass dust
I did mix in a piece of 338 S&B brass, so its 159 Hornady and 1 pc S&B.
Price shipped to continental US. $250
If you want, for another $50 I will prime them with Remington 9 1/2 Large Rifle Magnum primer.
Thanks for your consideration
