I am re-evaluating my load for .308 and loaded 25 rounds,5 shot groups) from 45.4 to 45.8 gr. of Varget with Berger 168 VLD seated into the lands, oh yea and prepped Lapua brass. Since I cant seem to upload photos I need to describe each group.
45.4 nice cluster .5 inch printed at 6 o'clock of my target,a 1 inch square) standard dev.-11
45.5 again .5 inch at 7 o'clock sd - 8,45.5 has consistently given less than .5 inch groups with fire formed brass)
45.6 .75 in. at 9 o'clock sd 23,three shots group well 2 shots higher on paper more at 11 o'clock)
45.7 .5 inch at 9 o'clock again but group moved more to a center location above 6 o'clock . Sorry that's the best way I can describe it. sd 26
45.8 .75 in. 3 rounds dead on 9 o'clock 2 rounds above 6 o'clock just as 45.7. sd 32 horrible.
As quoted by Lynn from another thread: "As you incrementally increase your powder charge the bullets should start low and go up.When you reach a plateau the bullets tend to go to the right somewhat and roll-off very slightly.After that the bullets will center up again and hit higher.
If your a good note taker and watch your conditions like a hawk you will get great accuracy from the load that went slightly right and rolled-off."
The way I view these groups is that 45.5 is the "roll off to the slightly" load. It also gave the lowest es and SD with 45.4 and 45.7 close behind. Am I correct in choosing this load. I have never done ladder testing but I like the theory and it definitely helped my .22-250 but the variations were easier for me to see in the .22-250. If I shot all the above listed loads at the same bull the group would not be over 1 inch and to me that is outstanding considering the nearly .5 grain difference in charge weight.
45.4 nice cluster .5 inch printed at 6 o'clock of my target,a 1 inch square) standard dev.-11
45.5 again .5 inch at 7 o'clock sd - 8,45.5 has consistently given less than .5 inch groups with fire formed brass)
45.6 .75 in. at 9 o'clock sd 23,three shots group well 2 shots higher on paper more at 11 o'clock)
45.7 .5 inch at 9 o'clock again but group moved more to a center location above 6 o'clock . Sorry that's the best way I can describe it. sd 26
45.8 .75 in. 3 rounds dead on 9 o'clock 2 rounds above 6 o'clock just as 45.7. sd 32 horrible.
As quoted by Lynn from another thread: "As you incrementally increase your powder charge the bullets should start low and go up.When you reach a plateau the bullets tend to go to the right somewhat and roll-off very slightly.After that the bullets will center up again and hit higher.
If your a good note taker and watch your conditions like a hawk you will get great accuracy from the load that went slightly right and rolled-off."
The way I view these groups is that 45.5 is the "roll off to the slightly" load. It also gave the lowest es and SD with 45.4 and 45.7 close behind. Am I correct in choosing this load. I have never done ladder testing but I like the theory and it definitely helped my .22-250 but the variations were easier for me to see in the .22-250. If I shot all the above listed loads at the same bull the group would not be over 1 inch and to me that is outstanding considering the nearly .5 grain difference in charge weight.