262 vs 272 nk

[Preacher]

Well I wish it wouldn't have rained on the parade.
I've been patiently waiting to find out jackies 272 neck test results so I could make up my mind about my new 1 in 8 Pac-Nor neck size.
All they have is a 262 and a 272, I think I would go with the 269nk if they had one.
I have no problems with turning necks,I do on my two other 6br's)......
Just wondering if I should use the 272 no turn, or spring for a 269 reamer, or go with the 262nk ?????
This will be going into my new BAT action,darndest, best looking action I have ever seen, that I just got from Mike )

 

[dantec]

I have 0.271 and get very good accuracy without neck turning pain, Lapua brass with just flash hole deburring YES Lapua have burrs inside )

I have a 0.269 and get a bit more stable accuracy in a batch, that allow to clean the neck surface and remove hight spot that allow to get a more esay neck sizing with bushing, more your neck OD is round, more your neck tension is stable, round OD make round ID )

forget neck under 0.266, neck thickness will be to thin excpet for perhaps pure BR shooting but gain between 0.269 and 0.262 will be in the .00000 so no need to loose time and money

good shooting

DAN TEC