WANTED 25-284 dies and reamer

[jeffreybehr]

These are somewhat hard to find.. Pls PM if you have something available.

 

[wvlongshot]

I've got several different dies and maybe a reamer. Pm incoming

 

[DJSBRS]

I have a set and reamer if wvlongshot doesn't come through.

DJ

 

[Copper11]

You can rent a reamer from 4d

 

[Copper11]

You also can use a 6.5x284 bushing die

 

[DJSBRS]

You also can use a 6.5x284 bushing die

Most bushing dies do not size all the way down the neck to the shoulder. Thus the bottom 1/4 of the neck does not get sized. Using 6.5 284 brass will not chamber then.

DJ
DJ's Brass Service

 

[284winner]

Most bushing dies do not size all the way down the neck to the shoulder. Thus the bottom 1/4 of the neck does not get sized. Using 6.5 284 brass will not chamber then.

DJ
DJ's Brass Service

My Redding Died do. I can get them about as far down as needed. Good point tho. I know some guys that have had that issue. I had my bushings made by a machinist so there's that. Most are shorter and so not size the neck down far enough

 

[alintx]

I may have a reamer, at least I did have if I didn't sell it. Cut two chambers with it at low rpm

 

[alintx]

Found it. 25/284 clymer. Cut two Chambers at 52rpm. $75 shipped

 

[wvlongshot]

My reamer is for a 6. He'll have to get a reamer from you guys. Won't be able to ck my dies till later today.

 

[jeffreybehr]

I have a set and reamer if wvlongshot doesn't come through.

DJ

You're next.

I'll PM you.

 

[Copper11]

That's y redding makes a body die after 3 to firings run in it n good to go

 

[Copper11]

Most bushing dies do not size all the way down the neck to the shoulder. Thus the bottom 1/4 of the neck does not get sized. Using 6.5 284 brass will not chamber then.

DJ
DJ's Brass Service

Never had a problem doing it this wsy