22br .100 short

[SPRING]

Can someone explain how to make 22br .100 short. Thanks Robbie

 

[RGRobinett]

Though I usually make mine .200" short, you simply run the reamer in .200" short on the "GO" gage - actually, I have a .200" short "GO" gage. So, you'd simply use .100" short on the "GO" and shorten the dies the same amount. I then use a set of Skip Otto form dies,shortened .22 BR form dies work OK)to place the shoulder where I want it, then trim to MAXIMUM OAL, turn the necks and fire-form. Your gunsmith should be able to "remodel" any of the available .22 BR FL or FL/NK bushing type dies to accommodate resizing needs.desires. DITTO the seater - I usually use a WILSON chamber type seater, made using the chamber reamer. The .200" short version has about the same capacity as a .222 Rem.; these are a pain to make, but perform very well. Good luck. R.G.

 

[rangertim]

spring I used a reading form & trim die to make my 110 short 6br,
I had 110 taking off the bottom of the die.Like randy said not that bad.