Mblmotors
Gold $$ Contributor
Please see photographs attached for details.
This is a 21st Century neck turning / trimming setup.
You get 2 Red bodies with neck trimming cutters in the bodies. The cutters installed are 6mm and 30mm. The way it works, the cutter in the red tool, will chamfer the outside of the neck, while the 2nd cutter in the special mandrel with trim the neck and do inside chamfer as it cuts. You just line up the two cutters any way you prefer. You can regulate the length on depth of chamfers.
In addition, I have 3 more mandler cutters in 22,26,and 28 calibers. So you pretty much have the most common rifle cartridges covered. All are super sharp. I don’t think I used 22,26.28 cutters. Each mandrel with the cutter is $80 on 21st Century site. Thats on top of the cost of the Red tool and cutter in that tool.
In addition, I am including 5 neck turning mandrels for this tool. They are all coated with slick finish or nitrited to help reduce friction. Please see photos for the the calibers.
I believe to cost to purchase new was about $900.00. I am offering for less then half. You can purchase cheap neck expanding steel mandrels to complete the whole setup at 21st Century to perfectly match the Neck Turners in this listing.
Asking $425 for everything.shipped conus.
This is a 21st Century neck turning / trimming setup.
You get 2 Red bodies with neck trimming cutters in the bodies. The cutters installed are 6mm and 30mm. The way it works, the cutter in the red tool, will chamfer the outside of the neck, while the 2nd cutter in the special mandrel with trim the neck and do inside chamfer as it cuts. You just line up the two cutters any way you prefer. You can regulate the length on depth of chamfers.
In addition, I have 3 more mandler cutters in 22,26,and 28 calibers. So you pretty much have the most common rifle cartridges covered. All are super sharp. I don’t think I used 22,26.28 cutters. Each mandrel with the cutter is $80 on 21st Century site. Thats on top of the cost of the Red tool and cutter in that tool.
In addition, I am including 5 neck turning mandrels for this tool. They are all coated with slick finish or nitrited to help reduce friction. Please see photos for the the calibers.
I believe to cost to purchase new was about $900.00. I am offering for less then half. You can purchase cheap neck expanding steel mandrels to complete the whole setup at 21st Century to perfectly match the Neck Turners in this listing.
Asking $425 for everything.shipped conus.
Attachments
Last edited:
