I thin if you use fbook 10 you'll get 10% off, not much but it could helpAnyone find an inexpensive replacement rubber washer for the 21st century neck lathe?
(Ordering direct is very expensive to ship like $25)
Linko,It’s a Flat washer, 2mm thick 15mm OD 5.6mm ID
Not a usual washer. I looked at many many on Amazon.
Thought someone here might have done this before.
I sold mine to BeefyT11 a couple years ago and hadn’t used it in several years before that. I actually forgot about those O rings I was actually thinking about the one on the shell holder. But I bet regular O rings would work for all of themThere are O rings on the screw as it passes through the lathe upright, and a rubber washer on the inside, that will deform if you tighten it too tight.
View attachment 1563349