• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

219 Donaldson Wasp "short"?

There are in fact two versions of the cartridge, a long version and short. It is unclear which of these is the original. The short version has a body length 0.050" shorter than the original. Furthermore the neck length of the short version was reduced by 0.040" to remove what might be considered excessive neck length by some shooters, suggesting the short version might be the newer design. This results in a finished overall case length 0.098" shorter than the long version (1.715" versus 1.813").

219 Donaldson Wasp dies can be used to load rimless versions based on the 6.8 SPC case, producing necks lengths of .203" and .253" respectively.
Bob
 
Thanks for the reply! So when 219 Wasp dies are listed by a manufacturer, they're likely for the "long" version, correct?

Thanks again!

Tom
 
i would contact the mfg, if they were the later mfg then they may well be the shorter version.
you may want to take a chamber casting and measure it, Brownells has the product to do that.

Bob
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,875
Messages
2,205,035
Members
79,174
Latest member
kit10n
Back
Top