20 practical

[jepp2]

Less runout with the CH4D which is what I always use now for both necking down 223 brass and routine reloading of 20P brass.

Same here. It is the 3'rd die I use when forming 20P brass. Here is my setup.

 

[nmkid]

Ok I think have read all there is on the 20 practical. So the consensus is that I need to get a redding 223 full length s bushing die and probably 2 bushings. Lets just say I use a .235 and then a .230 bushing. Do I have to change the expander in that die to a 20 cal. size before I start? Again i'm ignorant on the bushing dies and then adding a caliber change into the mix has me confused. I Realize I will have to get a seater die also.
Thanks for the patience! Gary

I don't use the expander at all. Works just fine.