SELLING 2 left!! - Dandy “semi-super trickler” controller for FX-120i

[itchyTF]

I have enough components to make 2 more. Except for the printed boxes which I should have in a couple of weeks.

Once these circuit boards are gone I don't plan on getting any more.

For those of you who may not be familiar with this, do a search for "Dandy" and put my handle in for the member and you should get sufficient info as to what this does. The videos are a bit dated. The firmware has been updated a couple of times (added a few features) since the videos were made.

Picture shown for reference, does not include Dandy.

Price is still $165 shipped.

 

[TommyD11730]

+1 for this unit. I can't see how I lived without it once I got it.
No more click, click, click... pushing the buttons on the Dandy controller. Just set it and your off to the races.

 

[LD220]

Does the 165 include everything you need to plug it right in and go.?

 

[itchyTF]

Does the 165 include everything you need to plug it right in and go.?

PM sent

 

[itchyTF]

A few people have asked if this is a plug-n-play setup. Well, almost. The controller needs access to the trickler so one end of the cable that I supply needs to be connected to the trickler inside its control (button) box. A hole drilled in the box, some heat shrink applied (which I can supply) then wires trimmed to length and soldered. Also, the scale needs some settings adjusted which I show how to do in the manual. Lastly it needs a serial cable (which I don't supply) to go between the controller and scale. These can be had for less than $10. The cable's connectors are DB-9, male & female and straight through or null modem (switch selectable).
Although not perfectly plug-n-play it's as close as I could get it given the scale and tricker. The controller's flexibility allows you to tune the trickler the way you want it for 4 different powder types.

 

[itchyTF]

A thought - for those who may not want to tackle adding the cable to the button box, send the trickler (without the stand) to me and I’ll do it. However, the price would be $185 shipped.

 

[itchyTF]

^

 

[itchyTF]

^^

 

[itchyTF]

^^^

 

[itchyTF]

^^^^

 

[Runwilderness]

PM sent.

 

[itchyTF]

Another sold, 2 left.