anneal

  1. Note to self.

    Usually I like to learn by reading, asking questions, etc. Yesterday I taught myself a lesson in annealing, the hard way. Only anneal perfectly clean brass! I thought the brass was pretty clean but it seems maybe not so much. If the brass has any lube left, it migrates to the mid-line of the...

  2. Annealing color change

    I bought an Annealeez machine and am very happy with it. Easy to setup and a huge time saver. I annealed about 1400 rounds Rem 204 Ruger and 450 rounds Rem 20 Vartarg. I setup the machine to just turn the 750 deg F tempilaq clear (inside the neck). With no changes to time or flame, I noticed...
  3. Shooter13

    HELP! Annealing with a split

    Okay, 20 lb tank with a Y split hose and Benz O matic torches (2) I can't find a double male fitting to go between the hoses to the torch heads, going to a welding supply house tomorrow but does anyone know where or a part # for the double male connector? This is the Y hose part #...
  4. Shooter13

    Bench Source annealing machine

    Okay, just ordered one from Brownells (backordered) and what to know what else I need, I plan on getting a a "T" type hose that will supply both torches, I have the 20lb propane so I need 2 benz o matic heads? How is the tempiqul applied? What else?

  5. Annealing till glow or 750??

    So I have an annealeez. I also have 750 tempilaq. With the cheap hornady brass I have, if I turn the lights out the brass gets the deep glow right at 750 degrees. Perfect. Then when I do the lapua brass I turned to the same neck thickness to the hornady and run it through the annealer I...

  6. Lapua does not recommend re-annealing?

    Hey all, Was in Lapua’s website and for the 6.5 brass, they say they do not recommended Re-annealing their off the shelf factory annealed brass. Is their a reason for this? I know most on here anneal every time If I’m not wrong. So why does lapua say this and are they correct?

  7. When to anneal cases?

    How does one establish that it is time to anneal your cases? What do you look for? What are the the tell tail signs? JPM

  8. Annealing machine prototype 2

    I've been kicking around an idea for making a very simple annealing machine. I thought it should be very possible to only use one motor for all actions - loading a case, spinning in front of a flame and ejecting it after a set time. I did a couple of 2d MDF mockups, then built this thing...

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
168,053
Messages
2,245,923
Members
80,958
Latest member
paramedic

Share This Page

Back
Top