Poll: Fclass shooters

[savageshooter86]

Regular press or Arbor press with in line seating dies? Just interested to see answers on this.

Fclass Shooters input wanted

 

[Immike]

Hydro press with in line dies

 

[Jay Christopherson]

regular press (Dillon).

 

[B Nettesheim]

Hydro with in line dies

 

[jamesh]

I switched from Wilson inline seater and arbor press for my 6mm Dasher to a Forester Ultra Micrometer Seating die in a Rockchucker press. I'm much happier now! I have no intention of going back.

 

[memilanuk]

I've got both setups... but currently my Forster Ultra BR die gives more consistent results than my Wilson, at least for my .308 Win with Berger 200s. Go figure.

 

[Archer]

Forester Ultra Micrometer Seating die in a Rockchucker press...

 

[Sniper338]

Hydro arbor press and inlines

 

[Endyo]

I use a Dillon

An RCBS Rockchucker / Redding Turret

And a Hydro Seater with Wilson die.

The Wilson die has slightly less R/O and more consistent seating depth.


A lot of times I'll seat bullets long and then finish them off in the Hydro Press.

 

[swd]

Rockchucker with Forster, Whidden or Redding dies depending on the rifle. I like the Forsters the best.

 

[Pappy42]

21st Century hydro press and inline die. Looking for consistent seating pressure. The ones that vary, I use for sighters.

6 Dasher and .284 Shehane both go consistently in the .1s and .2s out to 600 and slightly more at 1000 when I do my part and I can get up before daylight, setup and beat the wind. After the wind comes up, it beats me like a borrowed mule.

I've got a Whidden micrometer seating die that I use at the bench when I'm chasing seating depths.

 

[Rope2horns]

21st Century hydro press and in-line die.

 

[Keith Glasscock]

I use a Wilson die and a hammer... Go figure

Seriously, I seat in two separate operations (three if you count the pre-seating checks). None of which makes my ammo any better - I promise

 

[Cody Richardson]

Hydro arbor press with Wilson dies.

 

[Lbart]

I use an OLD Rockchucker press and Redding or Whidden dies.

 

[USMC-FF]

I use a K&M arbor press with Wilson seating die.

 

[dannyjbiggs]

Sinclair Arbor Press and Wilson Seating dies for seating bullets. Lyman Orange Crusher and special Whidden Gunworks FL dies (without expander ball assemblies) for sizing. K&M expander mandrels for standardizing case necks...F-Open.

Dan

 

[Toejoe12]

21st Century Hydro press.....Wilson seater

 

[Catfur]

Forester Press w/ Forester or Redding micrometer seating dies.

 

[Immike]

Excellent thread Savageshooter 86 , I hope to see more of these good questions!