SELLING SPF *ALBRECHT 1/2" CAPACITY CHUCK

Discussion in 'Tools, Dies, Rests, Reloading Components & Misc' started by luckyshot52, Jan 24, 2020.

Trader History (119)
  1. luckyshot52

    luckyshot52 Gold $$ Contributor

    Joined:
    Dec 21, 2011
    Messages:
    217
    1/32-1/2 " capacity Albrecht chuck with 3/4" straight shank. J-6 taper. Excellent condition. Great for holding small parts in a chuck on the lathe or mill.
    $125 shipped
     

    Attached Files:

  2. TAJ45

    TAJ45 Gold $$ Contributor

    Joined:
    May 12, 2007
    Messages:
    2,200
    These are NICE!!! Well worth it. imo. Used them daily. Wish I had a lathe and needed one.
     
  3. Aceball

    Aceball Gold $$ Contributor

    Joined:
    Jan 9, 2007
    Messages:
    49
    I'll take it. PM payment details.
     
  4. Dusty Stevens

    Dusty Stevens COVFEFE- Thread Derail Crew Gold $$ Contributor

    Joined:
    May 8, 2014
    Messages:
    15,294
    Wish it had an r8 on it mine is getting worn
     
  5. Stumpy1

    Stumpy1 Gold $$ Contributor

    Joined:
    Nov 27, 2013
    Messages:
    146
    Hi Dusty,

    You know that you can rebuild your Albrecht, right? It's not dirt cheap, but replacing the jaws is pretty much all you need to do.
    That and a good clean/relube will bring her right back to new condition.

    https://www.mscdirect.com/industrialtools/albrecht-keyless-drill-chuck-parts.html

    Hope you find this useful,

    Frank
     
    Dusty Stevens and smoooth like this.
  6. Dusty Stevens

    Dusty Stevens COVFEFE- Thread Derail Crew Gold $$ Contributor

    Joined:
    May 8, 2014
    Messages:
    15,294
  7. Stumpy1

    Stumpy1 Gold $$ Contributor

    Joined:
    Nov 27, 2013
    Messages:
    146
    You are very welcome, Sir.

    Frank
     

Share This Page