if your mill has a tilting head you can use a regular endmill, the angle depends on the size of the mill and the radius to cut, I do it all the time
Bob shot his Dasher
a ring die, for web sizing to fix bolt click
looks like drag marks on the cocking piece on the left, which would explain where the interference is
short answer, no
fireforming works best with virgin cases
yeah, Jim's a legend in CA shooting sports
contact Doan Trevor
One of my good customers sent me a photo from this mornings New Mexico hunt:
Stealth-Hunter takedown rifle
Pierce Engineering titanium action...
Arizona? what part?
One of our customers sent a few targets he shot with his Stealth-Hunter Rifle :D
use the C series (air dry)
I had the opportunity to set with an engineer from a well known powder company for an hour in my office not long ago, one of the topics that came...
I've shot a pile of the 6.5 CM 147 grain TAP and Match ammo, the Tap is better in the two rifles I tested, in speaking with a Hornady engineer, he...
2019 Berger SWN, first (Dasher) and second place (BRX) "any rifle" running Hornady 108 ELD-M
you can see on the bolts pictured, the one on the left (Rem 700) the cocking piece notch is further away from the end of the cocking ramp (note...
if it were mine I'd probably look at ignition, a customer had a similar problem (primer did blank), turned out the tip of the firing pin became...
GB is a joke, the system is run by bots, not sure if there are any actual people at GB (except the buyer/sellers) I quit my account there, still...
Separate names with a comma.