I am looking for a rather simple program for a smart phone. I like to store info and be able to chaange conditions, namely wind. Since I am...
Adam, I have about about 25 years shooting chucks and still do not know anything about the species. I have shot two areas and find that the so...
I have been shooting the 75 gr. Hornady HP for years with 46 grains of 4350, surplus powder, with CCI primers in a Sako HB. Winchester cases. Best...
Some 40 years ago, a friend had a 7mm built on a 300 weatherby case. He loaded a 175 Speer Grand Slam bullet(if memory serves me correctly). I do...
Most of you have far more experience than I with weighing and sorting cases. Having progressed from Rem or Win to LC cases, I have discovered...
watercam, the barrel has been replaced. This barrel has no firecracks in it, just what could be described as a spider web pattern, especially near...
I posted some time ago about a 223 barrel with etching all through the barrel. I suspected it might have something to do with the powder and quite...
I have been using Benchmark with the 40 vmax. Accuracy is in the .200 or smaller. I am running 3750. Since I dial, higher velocities are not...
370bc..... I had one of the early Browning Citori's that would have rust in the barrel after 30 minutes of not brushed and oiled. It happened...
Well, I got a reply from the powder company. It is from the email and copied to be exact. oad data Ramshot Customer Service...
I believe that in answering a question, it has gone into the realm of more questions. I know for fact the cosmoline had been removed from the...
Guys, please understand that I have not used Sweet in near 5 years. When Wipe Out came out I started using it. I just checked a 25-06 and a Sako...
Let me just say, my method has not created a problem with any other guns with carbon steel or stainless barrels. I dry patch after brushing for...
I purchased a 527 223 HB in Carbon Steel. The accuracy dropped off at around 1000 rounds and it was replaced. Gunsmith said it was pitted in lots...
Just reading the posts on this subject, makes me feel warm and fuzzy inside. Seldom do we see the joy in someones accomplishments as if it was...
I had the same problem with runout. I simply screwed the expander plug and shaft up very high in the FL die. Once I had full length resized, I ran...
I finally gave up on commercial brass and scrapped it all. I am using LC 223 brass to form 20 TAC brass along with 223. The weight is much closer...
I have two 20 TACs, one a PacNor and one Shilen. The PacNor shoots 40 Vmax easily into 1 and 2's when I do my part. The Shilen is not quite as...
Although I was shooting PacNor barreled guns, I had the same problem. Went to weighing cases and found that the fliers came from cases with much...
onelastshot....It is good to see you post using sitting or prone where there is movement and the trigger goes off at the opportune time. We've...
Separate names with a comma.
