Well the next morning I called RCBS and told them my problem and the guy said to send it back and they will ship out a replacement unit in about 2...
Glad to hear that your measurement issue is resolved. Just curious - was the rifle a Savage ?
I have a problem in that my unit seems to drift. I called RCBS and the tech had me tap it till the "LO" code came up and then tap it 50 times...
Pull the bolts out, clean them and then visually inspect them under perhaps some low magnification ( 5-10X) to evaluate the surface finish of the...
I was wondering about what percentage of barrels get cleaned without using bore brushes ?
This is a very entertaining and funny thread. I really needed it.
Perhaps cant has some influence.
I also used a hornady tool and got very positive readings on my Remington. Started .030 out and went to .030 beyond the lands in .030...
I have done it at the range by accident. I carry a wooden dowel in my case now.
Is there any harm in doing this?
What type of water should be used - good old mineralized water ?
Also at what temperature should this process be done?
Try IMR 8208 XBR.
K22 and all others, thanks for your ideas. Just to clarify the specific stage of my load development is OAL. I shoot 4 rounds into each target...
I have noticed a problem @ 2 weeks ago. My shots are left of the point of aim. Today I was left of aim on 29 out of 34 shots. The amount...
I have used PMC brass for reloads and have 4 cycles without annealing or full-length resizing. Case length trimming, primer pocket depth...
Bradley, are you using the above in a non-bolt action gun?
Mattri, I have not had any problems at all with my Fat Wrench.
I have been using the Fat Wrench of Wheeler Eng from MIdway for 3 years and have no problem with it
I am using a 700 SS 5R in 223 cal. with Lee collet die set and Nozler once fired brass from the same rifle. I have obtained some very accurate...
i am shooting (Cu) fmj 52 gr hornady match. i can not find them in 500 quantity lots.
Separate names with a comma.