Mad_Charlie's Recent Activity

  1. Mad_Charlie liked DirtySteve's post in the thread Where's the Varget?.

    Because everyone reading this thread bought some.. lol.

    Sep 19, 2019 at 4:24 AM
  2. Mad_Charlie liked Ned Ludd's post in the thread Where's the Varget?.

    Hopefully, the OP is still reading this post and now knows the answer to the never-ending, and possibly most important question in the...

    Sep 19, 2019 at 4:23 AM
  3. Mad_Charlie liked Ledd Slinger's post in the thread The MIGHTY Power of a Primer Change.

    Here you go Paul - @boltfluter Snapped a few quick photos for you. Not sure if you remember the rifle specs so I listed them below as...

    Screenshot_20190918-143745_Gallery.jpg Screenshot_20190918-143759_Gallery.jpg Screenshot_20190918-143809_Gallery.jpg Screenshot_20190918-143814_Gallery.jpg Sep 18, 2019 at 7:28 PM
  4. Mad_Charlie replied to the thread GEMPRO 250 Scale problems.

    The new people are always resurrecting zombie threads, on all forums, seems like. They can't help it I guess, but I'm sure they don't...

    Sep 17, 2019 at 2:11 PM
  5. Mad_Charlie liked Ledd Slinger's post in the thread The MIGHTY Power of a Primer Change.

    Fair enough, but isn't that the whole point of building custom rifles and handloading ammunition? If we dont want the smallest groups...

    Sep 16, 2019 at 7:44 PM
  6. Mad_Charlie liked Steve Blair's post in the thread Where is neck sizing taught.

    Golf? That's cold, man.

    Sep 16, 2019 at 6:24 AM
  7. Mad_Charlie liked Dusty Stevens's post in the thread Wilson Ultra Seater die issue.

    Too much neck tension will do that. Try some lapping compound on a bullet and spin it in there- deglaze it a bit

    Sep 15, 2019
  8. Mad_Charlie liked kneedtospeed's post in the thread Wilson Ultra Seater die issue.

    Prob Trump's fault...

    Sep 15, 2019
  9. Mad_Charlie liked ShootDots's post in the thread Do these look too hot?.

    I believe what you have is an "unbushed" bolt face / firing pin assembly. The primer cratering is from the primer, under pressure, being...

    Sep 15, 2019