hoz53's Recent Activity

  1. hoz53 replied to the thread Has anyone used this fella for a barrel?.

    so basicly he sold you a savage dropin he made with an Xcaliber blank for 300.00 total? is that correct?

    Jan 20, 2020 at 8:28 PM
  2. hoz53 liked Mark W's post in the thread Lucas Trans Treatment to replace grease.

    ......and I use 30 weight Mobile 1 synthetic for gun oil. A quart lasts for a loooong time!!

    Jan 20, 2020 at 8:23 PM
  3. hoz53 liked butchlambert's post in the thread Static converter or VFD.

    I have 2 rotaries and 2 VFDs in my shop. The rotaries are both outside with a little roof over them and beside my compressor. I use a...

    Jan 20, 2020 at 2:04 PM
  4. hoz53 replied to the thread Static converter or VFD.

    yes the DRO would probably need powered seperately and probably the table and knee travel motors and that power draw bar.

    Jan 20, 2020 at 7:46 AM
  5. hoz53 replied to the thread Static converter or VFD.

    isnt the variable speed on a bridgeport like that mechanical-- i think so. i would leave the machine speed on one setting and get a vfd...

    Jan 19, 2020 at 9:31 PM
  6. hoz53 replied to the thread CMP 1911s.

    well i risked the luck of the draw and have my CMP 1911 now. Dont know if im happy about that or not. I did get a parts gun in nice...

    Jan 19, 2020 at 9:07 PM
  7. hoz53 liked CT10ring's post in the thread Its really winter now!.

    Jon, stay warm, brother. Bet it's at least as cold as Idaho. Spent a winter in Rochester, NY. some snow here. hard livin makes hard...

    Banner Creek Summit ID.jpg saw_5.jpg Sawtooth_Stanley_ID_9.jpg Jan 19, 2020 at 5:57 AM
  8. hoz53 replied to the thread Its really winter now!.

    9 degrees here this morning- we have got around 6 inches of snow in the last 48 hours- N indiana- looks like winter finally made it and...

    Jan 19, 2020 at 5:57 AM
  9. hoz53 replied to the thread Help With New Dies Please.

    the coax is a great press - i sure like mine but just wanted to let you know- i think youll like it

    Jan 19, 2020 at 5:41 AM
  10. hoz53 replied to the thread Help With New Dies Please.

    most presses do flex and like ringo said a press that flex's less is better IMO. In my experience with the coax I havent always been...

    Jan 18, 2020 at 2:11 PM
  11. hoz53 replied to the thread Bench/press layout question.

    i to have had quite a few different loading benches over the years, always against a wall. like you my last bench i made an island -- i...

    Jan 17, 2020 at 6:45 AM
  12. hoz53 liked birdog's post in the thread Rem 700 External Bolt Release.

    Mike Bryant did this for my 700 Titanium action this week [ATTACH]

    Titanium Bolt stop Mike bryant.jpg Jan 17, 2020 at 3:37 AM