Joe R is this dwell time in the sizing die? I have never let the brass set in the die. Just in then back out. I am slowly learning. Should this be...
Decent prices on bullets and brass.
Here are 2 starrett 98 levels. One looks as though the calibration may have been fooled with and no box so you will have ro go through the...
After checking my 180gr .308 prohunters (I actually forgot I had them and stumbled across them a couple hours ago) they favor a lot.
I was guessing corlokt or grand slams.
I'm a lead nose fan for bolt guns too because I never shoot a deer over 75yds. I've just had good luck with them.
They measure .277-.278. It would be awsome if they were .30cal
Well I was hoping for a .284 but 233 bullets for $35 ain't bad so i jumped on it but I can't use them. I may post in classifieds
Picked these up today as a grab bag. 149ish grains at .278 on my caliper. I' assuming 270/6.8. Looks like a good deer buster for 100yds and under...
Size neck in steps maybe. My remy necks fired measures .345 but I need .336 so try to size them in 2 steps and may end up doin 3 steps. Body ,...
Separate names with a comma.